Electrical

CU MEC (R)350-750 (T)8SOL UL CSA

CU CMP 2 T UL

INS (2) 3/0-6,2/0-6FX,1-6M T UL CSA SINGLE ENTRY

AL MEC INS (A)500-2 (B)500-2 UL CSA

CU CMP 2/0 AWG 9/16-1-3/4 T UL CSA LONG BARREL WITH SIGHT

CU CMP 350 kcmil 9/16-1-3/4 TUL CSA LONG BARREL, NO SIGHT

CU CMP 4 AWG 13/32 T UL CSA SHORT BARREL, WITH SIGHT

CU CMP (R)250-500 (T)4-2 B UL

CU CMP 6 T UL CSA LONG SLEEVE

AL MEC (M)1/0-8 (T)(4) 2-14 ULMOUNTABLE

STL SCR 1/4-28X 7/16 SLT Z UR CSA

Surge protective devices (SPDs) provide equipment protection from transient overvoltage events lasting microseconds. By limiting the overvoltage to the equipment during these events, costly damage and downtime can be mitigated. The NEMA-style SPDN series...

Surge protective devices (SPDs) provide equipment protection from transient overvoltage events lasting microseconds. By limiting the overvoltage to the equipment during these events, costly damage and downtime can be mitigated. The NEMA-style SPDN series...

The SE-134C/SE-135 is a microprocessor-based, combination ground-wire monitor and ground-fault relay for resistance grounded or solidly grounded systems. It continuously monitors the integrity of the ground conductor to protect portable equipment from...

The SE-105/SE-107 is a combination ground-wire monitor and ground-fault relay for resistance-grounded systems. It continuously monitors the integrity of the ground conductor to protect portable equipment from hazardous voltages caused by ground faults...

The MP8000 series motor protection relay is designed to protect three-phase or single-phase motors with operating voltages of 90-690 V ac (use of external potential transformers can extend upper voltage range above 690 V ac). The MP8000 protects any...

The LSRX/LSRX-C Series are AC current sensors designed to energize the output contact whenever 4.5 Amps or greater is present. The LSRX/LSRX-C Series is used commonly as an AC current proof relay to indicate if a motor is operating. It can also be used...

The ARP Series is used in systems where equal run time for two motors is desirable. The selector switch allows selection of alternation of either load for continuous operation. LED’s indicate the status of the output relay. This versatile series may be...

The ALT Pump Controls series is used to alternate between two loads and is commonly used in duplex pump-up and pump-down applications to balance the run-time of both pumps. The ALT relays have a built-in debounce time delay that prevents the relay from...

The ALT Pump Controls series is used to alternate between two loads and is commonly used in duplex pump-up and pump-down applications to balance the run-time of both pumps. The ALT relays have a built-in debounce time delay that prevents the relay from...