Hand Tools

Scribers are steel, properly tempered and well finished. The points are finely tapered so that the scriber point can be easily seen on the work. The handle, as well as the points, have a knurled grip. Scriber with 2 Points grip.

The Saw Tension Gage checks for proper blade tension in either English or metric, and is graduated both in pounds and kilograms. The tension gage can be read directly on either band saws of any type, or power hacksaws.

These gages directly measure the diameter of chamfered holes. No setting master is necessary. When the three-blade plunger is pressed against a fl at surface, the gage should read the set number stamped on the back of the indicator. In case of wear, the...

These gages directly measure the diameter of chamfered holes. No setting master is necessary. When the three-blade plunger is pressed against a fl at surface, the gage should read the set number stamped on the back of the indicator. In case of wear, the...

These gages directly measure the diameter of chamfered holes. No setting master is necessary. When the three-blade plunger is pressed against a fl at surface, the gage should read the set number stamped on the back of the indicator. In case of wear, the...

These gages directly measure the diameter of chamfered holes. No setting master is necessary. When the three-blade plunger is pressed against a fl at surface, the gage should read the set number stamped on the back of the indicator. In case of wear, the...

Internal Chamfer Gage- 25-50Mm

These gages directly measure the diameter of chamfered holes. No setting master is necessary. When the three-blade plunger is pressed against a fl at surface, the gage should read the set number stamped on the back of the indicator. In case of wear, the...

These gages directly measure the diameter of chamfered holes. No setting master is necessary. When the three-blade plunger is pressed against a fl at surface, the gage should read the set number stamped on the back of the indicator. In case of wear, the...

These gages directly measure the diameter of chamfered holes. No setting master is necessary. When the three-blade plunger is pressed against a fl at surface, the gage should read the set number stamped on the back of the indicator. In case of wear, the...

Internal Chamfer Gage- 0-9.5Mm

Internal Chamfer Gage- 25-50Mm

Countersink Gage- 0.5-4.3Mm

Countersink Gage- 4-9Mm

Countersink Gage- 9-14Mm

Countersink Gage- 14.2-19.8Mm

Starrett Countersink Gages are offered in three different angles so that the gage sets on the angular side of the countersink, as opposed to a chamfer gage which sets on the top edge of the chamfer. .160-.360" Range, 90 Deg Angle with Case.

Countersink Gage- 0.5-4.3Mm

Countersink Gage- 4-9Mm

Countersink Gage- 14.2-19.8Mm