Hand Tools

These gages directly measure the diameter of chamfered holes. No setting master is necessary. When the three-blade plunger is pressed against a fl at surface, the gage should read the set number stamped on the back of the indicator. In case of wear, the...

Internal Chamfer Gage- 25-50Mm

Starrett Countersink Gages are offered in three different angles so that the gage sets on the angular side of the countersink, as opposed to a chamfer gage which sets on the top edge of the chamfer. .020-.170" Range with Case.

Countersink Gage- 0.5-4.3Mm

Countersink Gage- 4-9Mm

Countersink Gage- 9-14Mm

Countersink Gage- 14.2-19.8Mm

Starrett Countersink Gages are offered in three different angles so that the gage sets on the angular side of the countersink, as opposed to a chamfer gage which sets on the top edge of the chamfer. .160-.360" Range, 90 Deg Angle with Case.

Countersink Gage- 0.5-4.3Mm

Countersink Gage- 4-9Mm

Countersink Gage- 14.2-19.8Mm

Starrett Countersink Gages are offered in three different angles so that the gage sets on the angular side of the countersink, as opposed to a chamfer gage which sets on the top edge of the chamfer. .020-.170" Range with Case.

Starrett Countersink Gages are offered in three different angles so that the gage sets on the angular side of the countersink, as opposed to a chamfer gage which sets on the top edge of the chamfer. .160-.360" Range with Case.

Starrett Countersink Gages are offered in three different angles so that the gage sets on the angular side of the countersink, as opposed to a chamfer gage which sets on the top edge of the chamfer. .360-.560" Range with Case.

Starrett Countersink Gages are offered in three different angles so that the gage sets on the angular side of the countersink, as opposed to a chamfer gage which sets on the top edge of the chamfer. 0.5-4.3mm Range with Case.

Starrett Countersink Gages are offered in three different angles so that the gage sets on the angular side of the countersink, as opposed to a chamfer gage which sets on the top edge of the chamfer. 4-9mm Range with Case.

Countersink Gage- 9-14.2Mm

Countersink Gage- 14.2-19.8Mm

These hole gages will check hole diameters to .001" and 0.02mm. They are fast, accurate, easy to read and have a balanced design for easy one hand operation. The gage can be pressed down on a flat surface and checked so the size should read the same as...

Hole Gage- .25-1.00Mm