Hand Tools

PT22428. Will fit over spindles and posts 3/32-1/4" (2.4-6.3mm). Can be used directly on our 252 Height Transfer Gage and our 657 Magnetic Base Holders. It is frequently used on the 1/4" (6.3mm) rod of the Snug and Rod Unit PT22430.

PT22429. 3/16" (4.8mm) diameter rod. For use in chucks, collets or surface gage snugs.

Snug and Rod unit.

Depth Attachment for 6" (150mm) / 9" (225mm) Calipers (was 120D).

Cable 723/731/735/752/763/2500 to 723A/740/741/742/772/99413.

Cable- Data Ouput Shielded - 50'

PT22939 Adaptor, 9 Pin Female

1 5/16" (33mm) Length, .078" (2mm) Ball Dia., Steel.

1 5/16" (33mm) Length, .078" (2mm) Ball Dia., Carbide.

5/8" (16mm) Length, .032" (0.8mm) Ball Dia., Steel.

5/8" (16mm) Length, .032" (0.8mm) Ball Dia., Carbide.

1 5/16" (33mm) Length, .032" (0.8mm) Ball Dia., Steel.

1 5/16" (33mm) Length, .032" (0.8mm) Ball Dia., Carbide.

.030" Master for 690-1. Note: The side opposite of the laser mark, without the chamfer, should be used to master the 690 series hole gage.

.080" Master for 690-2. Note: The side opposite of the laser mark, without the chamfer, should be used to master the 690 series hole gage.

.180" Master for 690-3. Note: The side opposite of the laser mark, without the chamfer, should be used to master the 690 series hole gage.

.280" Master for 690-4. Note: The side opposite of the laser mark, without the chamfer, should be used to master the 690 series hole gage.

.75mm Master for 690M-1. Note: The side opposite of the laser mark, without the chamfer, should be used to master the 690 series hole gage.

3.00mm Master for 690M-2. Note: The side opposite of the laser mark, without the chamfer, should be used to master the 690 series hole gage.

Master- 5.00Mm Dia. Ring Gage For 690M-3